- OPIsystems Help Centre
- OPI Blue
-
OPIsystems Support
-
StorMax
-
OPI Blue
-
Upgrade Procedures
-
Moisture Cable
-
Cable Node
-
Integris
-
OPI Blue Release Notes
-
Advanced Grain Management FAQs
-
Temperature Cable
-
Temperature/Moisture Cable
-
Plenum Pressure Sensor (PPOT)
-
Install Guides
-
OPI Partner and Install Certification Information
-
OPIsystems Internal Knowledgebase
-
CO2 sensor
-
Fan Control
-
BLUE Lite
-
Warranty
-
EPIQ
Power loss/outage and reconnection on Node
This addresses questions regarding loss of power and reconnection of power on a node.
Question: How much time does it take to get notified of a power outage/loss and power reconnection?
Answer: The node is read every hour. Therefore you will get a notification of power loss or power reconnection every hour.
Question: If a node loses power and then regains it, will it reconnect automatically, or do I have to do the 5 sec reset and then remap it?
Answer: Mostly, yes it will reconnect automatically. Otherwise, it would mean the node has gone into a deep sleep mode and then a node reset (5 sec with red jumper) needs to be done.
Click here for instructions on How to reset a cable node
Click below for more details about deep sleep on a cable node.